V1.8.8 Xhorse VVDI BIM Tool BIMTool Pro Enhanced Edition Too Support BMW E-sys and Rheingold Diagnostic System

Latest price:US$1,068.00
US$929.0013% off
  • Item No. SK283-B
  • Free Shipping

Customer Questions & Answers

0
votes
Question:
Q:When to connect with Ethernet port?
Answer:
A:For FEM/BDC programming and other functions
When the connection is normal, it will show “connect 1: OK”.
Please kindly notice:
Don’t use USB cable and internet cable to connect BIMTOOL Pro and computer at the same time, otherwise it will fail to use!
By ErinWang Seller on Oct 23, 2022 0 of 0 found this helpful. Do you?

0 Votes
0
votes
Question:
Q:What is the difference between Xhorse VVDI2 & VVDI BIMTool Pro key programmer?
Answer:
A:Differences
VVDI BIMTool Pro has all the features of VVDI2, it also has E/F/G encoding and 8HP gearbox functions.
It adds an ethernet port to support coding & programming a single module via CAN/DOIP, which extremely increases the speed of coding and programming. Moreover, it also supports BMW’s latest FEM/BDC system.
Similarities
Xhorse VVDI2 and VVDI BIMTool Pro are both suitable for a locksmith, which are including the same features such as unit coding, OBD key learns, file makes learn…etc. The VVDI BIMTool Pro IMMO and KM function supported BMW car year similar to the VVDI2 BMW key programmer.
Their software installation is similar, both of VVDI2 and VVDI BIMTool Pro software free update online. Using Xhorse update kit software can free update firmware.
Conclusion
Xhorse VVDI2 commander is suitable for locksmiths, which is mainly used for key programming.
VVDI BMW BIMTool Pro is suitable for a car repair shop, which not only requires key programming but also requires coding & programming features for maintenance diagnosis.
By ErinWang Seller on Oct 23, 2022 0 of 0 found this helpful. Do you?

0 Votes
0
votes
Question:
Q:I received the package but Xhorse VVDI BIMTool Pro doesn't work. There was no connection with the car (either via CAN or KLINE bus). I updated the device to the newest software and firmware. any iead
Answer:
A:You should short the component in the following printed circuit board with a zero-ohm resistor below picture
By ErinWang Seller on Oct 23, 2022 0 of 0 found this helpful. Do you?

0 Votes
Total 23 items, 20 items/p, current page 2/2.
Don't see the answer you're looking for? Post your question